To better illustrate each case, examples of each category are shown in table below. The description of each exposure classification is detailed in Section 26.7.2 and 26.7.3 of ASCE 7-10. The exposure to be adopted should be the one that will yield the highest wind load from the said direction. Take note that for other location, you would need to interpolate the basic wind speed value between wind contours. When viewing the wind maps, take the highest category number of the defined Risk or Occupancy category.įrom Figure 26.5-1B, Cordova, Memphis, Tennessee is somehow near where the red dot on Figure 3 below, and from there, the basic wind speed, (V), is 120 mph. See Table 1.5-1 of ASCE 7-10 for more information about risk categories classification. Moreover, we will be using the Directional Procedure (Chapter 30 of ASCE 7-10) in solving the design wind pressures.įor this example, since this is a plant structure, the structure is classified as Risk Category IV.

Users would need to conduct manual calculation of this procedure in order to verify if the results are the same with those obtained from the software. Asce 7 10 Espanol Gratis Manual Calculation Of In this section, we are going to demonstrate how to calculate the wind loads, by using an S3D warehouse model below. In order to do so, guidelines on how to estimate this load is indicated in each local code provision.

Asce 7 10 Espanol Gratis How To Estimate ThisĪsce 7 10 Espanol Gratis How To Estimate This.

Asce 7 10 Espanol Gratis Manual Calculation Of.

Asce 7 10 pdf espanol